Mechanical Engineering Faculty Profile:

Dr. Jungho Kim
Professor of Mechanical Engineering

Phase change heat transfer process as applied to electronic cooling; investigation of fundamental heat transfer mechanisms in boiling and spray cooling in Earth and microgravity environments; high temperature radiation absorbance measurements.

(301) 405-5437 | kimjh@umd.edu | website | Room 3149, Building 088, Glenn L. Martin Hall

Education
Ph.D., University of Minnesota, Minneapolis, 1990

Recent Publications
Coursey, J. S., Kim, J., and Boudreaux, P.J., “Performance of graphite foam evaporator for use in thermal management”, Journal of Electronic Packaging, Vol. 127, No. 2, pp. 127-134, 2005.

Henry, C.D., Kim, J., “Thermocapillary Effects on Low-G Pool Boiling From Microheater Arrays of Various Aspect Ratio”, Microgravity Science and Technology, XVI, pp. 170-175, 2005.

Horacek, B., Kiger, K., Kim, J., “Single Nozzle Spray Cooling Heat Transfer Mechanisms”, International Journal of Heat and Mass Transfer, Vol. 48, No. 8, pp. 1425-1438, 2005.

Myers, J.G., Yerrramilli, V.K., Hussey, S.W., Yee, G.F., and Kim, J., “Time and space resolved wall temperature and heat flux measurements during nucleate boiling with constant heat flux boundary conditions”, International Journal of Heat and Mass Transfer, Vol. 48, No. 12, pp. 2429-2442, 2005.

Henry, C.D., Kim, J., Chamberlain, B., and Hartmann, T.G., “Heater aspect ratio effects on pool boiling heat transfer under varying gravity conditions”, Experimental Thermal and Fluid Science, Vol. 29, No. 7, pp. 773-782, 2005.

Henry, C.D., Kim, J., and McQuillen, J. “Dissolved Gas Effects on Thermocapillary Convection During Boiling in Reduced Gravity Environments ”, Heat and Mass Transfer, Vol. 42, pp. 919-928, 2006.

Silk, E.A., Kim, J., and Kiger, K. “Spray Cooling of Enhanced Surfaces: Impact of Structured Surface Geometry and Spray Axis Inclination”, International Journal of Heat and Mass Transfer, Vol. 49, pp. 4910-4920, 2006.

Moghaddam, S., Lawler, J., Currano, J., and Kim, J. “A novel method for measurement of total hemispherical emissivity”, AIAA Journal of Thermophysics and Heat Transfer, Vol. 21, No. 1, pp. 128-133, 2007.

Kim, J. “Spray cooling heat transfer: The state of the art”, in press, International Journal of Heat and Fluid Flow.

Coursey, J.S., Kim, J., and Kiger, K.T. “Spray cooling of high aspect ratio open microchannels”, in press, Journal of Heat Transfer.

Scientific and Professional Membership
Associate Editor, International Journal of Multiphase Flow, 2007-2010; Session chair for ASME and Engineering Foundation conferences; ASME K-13 Committee on Multiphase Heat Transfer; ASME Heat Transfer Visualization Committee; ASME Heat Flux Gauge Calibration Committee

Honors and Awards
ASME Fellow (2005).

ME Home | Faculty Listing  |  Staff Listing